₹4,999.00 ( Incl. GST )
This PM07 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated esc power & signal distribution for up to 8 ESCs.
PM07 has two 5.2V power output port that can provide redundant power to the flight controller, with independent circuits, BEC IC and circuitry.
It is also great for flight controller that do not have built-in servo header pins like the Pixhawk 6C & Pixhawk 4. It comes with pre-soldered wires, capacitor, and XT60 connector.
The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference.
This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital PM like PM02D).
1x PM07 board
1x 80mm XT60 connector wire (installed)
1x Electrolytic capacitor: 220uF 63V (installed)
2x JST GH 10P Cable
1x JST GH 8P Cable
2x JST GH 6P Cable
Input voltage | 2S-14S |
---|---|
PCB Cont. Current Rating | 90A |
PCB Burst Current Rating | 140A (<60 Sec) |
Output | DC 5.2V & 3A Max |
Voltage Divider | 18.182 |
Amperes per Volt | 36.364 |
Dimensions | 68*50*10 mm |
Mounting Holes | 45*45mm |
Weight (g): | 43.8 |
Shipping Weight | 0.065 kg |
Shipping Dimensions | 15 × 10 × 2 cm |
This item is covered with a standard supplier warranty of 3 months from the time of delivery against manufacturing defects only. This is a quality product & only manufacturing defects are covered under this warranty. Replacement will be done against manufacturing defects.
If the product is subject to misuse, tampering, static discharge, accident, water or fire damage, use of chemicals & soldered or altered in any way.
Reviews
There are no reviews yet